Logo

P3853 Engine Code Repair

Meaning of P3853 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P3853 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting

If one of these reasons for P3853 code is occuring now you should check P3853 repair processes.
Now don't ask yourself; What should you do with P3853 code ?
The solution is here :

P3853 Possible Solution:

P3853 Engine

Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.

P3853 Code Meaning :

P
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine

3
Ignition System Or Misfire

8
Fuel Rail Pressure Sensor Circuit Malfunction

5
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

3
Glow Plug/Heater Circuit 'A' Malfunction

Regarding the P3853 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.

P3853 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P3853 engine trouble code is about Glow Plug/Heater Circuit 'A' Malfunction.

Main reason For P3853 Code

The reason of P3853 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

P3853 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.